Edelbrock Yamaha Rhino 660 Bedienungsanleitung PDF herunterladen

INSTRUCTION SUPPLEMENT FOR

2004-Later Yamaha Rhino 660

Removing stock carburetor and cables

1. Remove engine cover and tunnel

(center of floor board).

2. Remove throttle cable from throttle

pedal and chassis. See fig 1.

3. Remove choke cable from dash.

See figure 2.

Figure 1. Throttle cable

Figure 2. Choke cable

4. Remove stock carburetor, cables

and all vent hoses attached to

carburetor. NOTE: Carburetor can

be removed without disconnecting

cables. Unplug black and yellow

wires from carb and tape ends with

electrical tape as they will not be

used with the Edelbrock carburetor.

5. Stuff a dry, clean rag into the

intake manifold to keep debris from

entering engine.

6. Remove oil line directly above oil

filter. See fig 3. Disconnect rubber

hose at bottom where it connects

to hard tube. See fig 4.

NOTE: Clean oil and dirt off of flange and

case before removing oil line.

Figure 3.

Figure 4.

7. Remove stock fuel line from fuel

pump. Save insulating material as

it will be reused on new fuel line.

Installing the Edelbrock Carburetor

1. Attach new fuel line to fuel pump

reusing stock clamp and insulating

material.

2. Install new throttle cable into bracket

and throttle pedal. Do not route

throttle cable in stock position. Cable

will need to be routed to passenger

side of vehicle. See figure 5 for cable

routing.

NOTE: Apply a small amount of grease to

O-ring on pedal end of cable for easier

installation into throttle pedal.

Figure 5.

1 2 3

Inhaltsverzeichnis

Seite 1 - 2004-Later Yamaha Rhino 660

INSTRUCTION SUPPLEMENT FOR 2004-Later Yamaha Rhino 660 Removing stock carburetor and cables 1. Remove engine cover and tunnel (center of floor boa

Seite 2

3. Remove the hex pipe plug from the carb cap using a 11mm or 7/16 wrench. Do not discard plug, as it will be needed later. Install the metering

Seite 3 - Specifications

NOTE: Turn elbow until it is just below three o’clock position as shown in picture above. 16. Install hose clamps on each end of supplied 3/8 hose

Kommentare zu diesen Handbüchern

Keine Kommentare

Edelbrock Yamaha Rhino 660 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Edelbrock Yamaha Rhino 660 herunter. Edelbrock Yamaha Rhino 660 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Edelbrock Yamaha Rhino 660